[. . . ] NOTE · Please be careful not to scratch the LCD panel or the cabinet with the panel protector during installation. [. . . ] With the enclosed tool (Lever) set the tabs of the panel protector into the side grooves (4 tabs). Put the lever on the tabs of the panel protector and move it toward the LCD panel to install. Position the protector into the LCD panel tightly without leaving an opening. Removing Put the lever on the tabs of panel protector and move it toward the cabinet to remove. Cleaning NOTE · Please be sure to keep the panel protector immobilized while cleaning it. To hold the panel protector by hand, use a soft cloth to avoid dust or finger prints. · Never use thinner, benzene, alcohol (ethanol, methanol, or isopropyl alcohol), abrasive cleaners, or other strong solvents, as these may cause damage to the cabinet or panel. · It is recommended to use EIZO cleaning kit "ScreenCleaner" (option) to clean the panel. The panel surface can be cleaned with a soft cloth such as cotton or lens paper. If necessary stubborn stains can be removed by moistening part of the cloth with water to enhance its cleaning power. Specification Surface treatment Coating strength Light transmission Dimension/ Weight Non-glare side: non glare hard coating / Glossy side: hard coating 2H More than 90 % FP-702: 379. 8 mm (W) × 304. 5 mm (H) × 1. 0 mm (D) / approx. [. . . ] 175 g Lever (for Panel Protector), User's Manual Accessories Copyright© 2006 EIZO NANAO CORPORATION All rights reserved. [. . . ]